Part Number: 428566
Weight (lbs): 2
Part Description: The Pressure-Operated Stackable Actuator (Part No.428566) is necessary when pneumatic actuation is required on any selector valve. This actuator is installed on top of the selector valve and a 1/4 in. pressure line must be attached to the 1/8 in. pressure port on the side of the actuator. The actuator must be manually reset

Part Number: 429847
Weight (lbs): 0.5
Part Description: The Booster Actuator, Part No. 428949 requires resetting after actuation. A Reset Tool, Part No. 429847, is available for this use.

Part Number: 70846
Material: Brass with Stainless Steel Pin (All Manual Cable-pull Actuators)
Weight (lbs): 1.4
Part Description: Lever Release (1 1/4-18 mounting thread) – Mounts directly to an HF electric actuator.
Material: Brass with Stainless Steel Pin (All Manual Cable-pull Actuators)

Part Number: 75433
Weight (lbs): 0.1
Part Description: An arming tool, Part No. 75433, is required to reset the actuator after operation. The actuator contains a standard 1/2 in. threaded female straight connector for electrical conduit hookup.

Part Number: 428949
Part Description: The Booster Actuator, Part No. 428949, is used when electric actuation is required on the selector valve or the CV-98 cylinder valve. The actuator mounts directly to the component and then a HF electric actuator mounts to the top of the booster actuator.
Weight (lbs): 2.6

Part Number: 441870
Part Description: The placement indicator switch 1/2 in. – 14 NPSM is a monitoring device to indicate proper placement of the system electric actuator. The switch mounts directly to the actuator, and is active when the sensor switch is depressed, allowing a small electric current to pass through the end-of-line (EOL) resistor.
Weight (lbs): 0

Part Number: 73327
Weight (lbs): 4.4
Material: Brass (Body), Stainless Steel (Plunger)
Thread Size/Type: 1/2 in. Straight Female
Description: Electrical actuation of an agent cylinder and/or selector valves is accomplished by an HF electric actuator interfaced through an AUTOPULSE Control System. This actuator can be used in hazardous environments where the ambient temperature range is between 0 °F to 130 °F (–18 °C to 54 °C). The HF electric actuator meets the requirements of N.E.C. Class I, Div. 1, Groups B, C, D and Class II, Div. 1, Groups E, F, G. A maximum of two HF electric actuators can be used on a single AUTOPULSE release circuit. When utilizing only one HF electric actuator, an in-line resistor, Part No. 73606, is required in the supervised release circuit.

Part Number : TIER7_SUB
Part Description : Container monitoring annual subscription fee TIER7 (100+ Containers per System)
Weight (lbs) : 0

Part Number : TIER6_SUB
Part Description : Container monitoring annual subscription fee TIER6 (50-99 Containers per System)
Weight (lbs) : 0

Part Number : TIER5_SUB
Part Description : Container monitoring annual subscription fee TIER4 (20-29 Containers per System)
Weight (lbs) : 0