Part Number: 426170
Material: Brass (Valve), Steel (Accumulator)
Weight (lbs): 30
Part Description: The time delay assembly uses INERGEN® pressure to power the factory-set delay mechanism. Install the assembly in the discharge piping, either directly after the control (pilot) cylinder or further along the piping. The assembly is reversible to accommodate right and left hand configurations and will operate in any mounting orientation. After the discharge is complete, pressure in the assembly slowly returns to normal and closes the time delay valve.

Part Number: 32338
Weight (lbs): 0.3
Part Description: Male Straight Connector (7/16-20 x 1/4 in. NPT)

Part Number: 31810
Weight (lbs): 0.1
Part Description: Male Elbow (7/16-20 x 1/4 in. NPT)

Part Number: 31809
Material: Stainless Steel (Stainless Steel Hose)
Thread Size: Female 7/16-20 (Both ends)
Weight (lbs): 0.2
Part Description: The Stainless Steel Actuation Hose, 16 in. (40.6 cm) is used to connect the actuation line flared tees between each agent tank. The hose has the same thread, 7/16-20, as the flared tees. The actuation hose allows flexibility between the rigid actuation piping and the tank valve.

Part Number: 5156
Material: Brass
Thread Size/Type: 1/4 in. NPT Female
Weight (lbs): 1,1
Part Description: By either pneumatic or manual actuation, the pressure trip can release spring or weight powered devices to close doors and windows, open fuel dump valves, close fire dampers or close fuel supply valves. The pressure trip is constructed of brass with two 1/4 in. NPT fittings for connection to discharge or actuation lines. The link on the pressure switch is released either pneumatically, by agent discharge pressure; or manually by use of the pull ring.

Part Number: 73236
Part Description: Pilot Valve Actuation Adapter
Weight (lbs): 0.1

Part Number: 32338
Part Description: Male Straight Connector (7/16 – 20 x 1/4 in. NPT)
Weight (lbs): 0.3

Part Number: 32336
Part Description: The Stainless Steel Actuation Hose, 24 in. (60.9 cm) is used to connect the actuation line flared tees between each agent tank. The hose has the same thread, 7/16-20, as the flared tees. The actuation hose allows flexibility between the rigid actuation piping and the tank valve.
Material: Stainless Steel (Stainless Steel Hose)
Thread Size: Female 7/16-20 (both ends)
Weight (lbs) : 1